Rear Bag Assembly

Ballast Install 006
Originally uploaded by gkemp

We put the pumps behind the access panel in the rear lockers. It made for a very easy run of hose and the wonder board is very easy to screw into. I drilled a hole below the access panel for the hose to connect to the bag. We ran the wire from the Port pump across the factory wires and up the side of the engine though the middle of the boat to the inside of the drivers helm. One thing to watch out for is the screws that they used to put in the table base stick out and are sharp! The last picture shows that. I have to go back and cut off the screw ends or buy smaller screws that don't poke though. If I fill the bag all of the way it will make contact and can pop the bag.